An automated laser fluorination technique for highprecision analysis of three oxygen isotopes in silicates
Cited 4 time in
Cited 5 time in
- An automated laser fluorination technique for highprecision analysis of three oxygen isotopes in silicates
- Other Titles
- 자동화된 레이저 불화방식을 적용한 표준규산염광물의 산소동위원소 정밀분석
- Kim, Nak Kyu
Lee, Jong Ik
Park, Sun Young
- Biochemistry & Molecular Biology; Chemistry; Spectroscopy
- Issue Date
- Kim, Nak Kyu, et al. 2019. "An automated laser fluorination technique for highprecision analysis of three oxygen isotopes in silicates". RAPID COMMUNICATIONS IN MASS SPECTROMETRY, 33(1): 641-649.
- Rationale: Oxygen three isotopes in terrestrial/extraterrestrial silicates can provide geochemical and cosmochemical information about their origin and secondary processes that result from isotopic exchange. A laser fluorination technique has been widely used to extract oxygen from silicates for δ17O and δ18O measurements with isotope ratio mass spectrometer. Continued improvement of the techniques is still important for high precision measurement of oxygen isotopic ratios.
Methods: We adopted an automated lasing technique to attain reproducible fluorination of silicates using a CO2 laser-BrF5 fluorination system connected online to isotope ratio mass spectrometer. The automated lasing technique enables us to perform high precision analysis of oxygen three isotopes of typical reference materials (e.g., UWG2 garnet, NBS28 quartz and San Carlos olivine) and in-house references (mid-ocean ridge basalt glass and obsidian). The technique uses a built-in application of laser control with which the laser power can be varied in a programmed manner with defocused beam which is in a fixed position.
Results: Oxygen isotope ratios of some international reference materials analyzed by the manual lasing technique were found to be isotopically lighter with wider variations in δ18O values, whereas those measured by the automated lasing technique gave better reproducibility (less than 0.2 ‰, 2SD). The Δ17O values, an excess of δ17O value relative to the fractionation line, were also show high reproducibility (±0.02 ‰, 2SD).
Conclusions: We have shown that the system described herein provides high precision δ17O and δ18O measurements of silicate materials. The use of the automated lasing technique followed by careful and controlled purification procedures is preferred to achieve satisfactory isotopic results.
- Files in This Item
- Can archive pre-print and post-print or publisher's version/PDF
Can archive post-print (ie final draft post-refereeing) or publisher's version/PDF
Can archive pre-print (ie pre-refereeing)
Archiving not formally supported
Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.